How to Replace a Gear Gaiter and Handbrake Gaiter (Any Car)

Most worn gear and handbrake gaiters can be replaced at home in under an hour. Cars use a handful of different fixings, so the most important step is to look at how your original gaiter is held before you pull anything. This guide explains the common methods we see in our Cornwall workshop and how to transfer a new gaiter onto your original frame.

Time needed: 30-60 minutes (plus adhesive curing time)

What you need

  • Plastic trim tools or a small flat-head screwdriver wrapped in tape
  • Pliers or side cutters
  • Cable ties (and a small hose clip if your car uses a one-use clamp)
  • Contact adhesive for automotive upholstery or an upholstery staple gun
  • A clean cloth and masking tape

Step by step

  1. Look before you pull

    Take a few photos of the gaiter, the surround and the knob from different angles. Note which edge of the gaiter faces forward and where the seams sit, so the new one goes back the same way.

  2. Release the surround or frame

    Most surrounds are clipped into the centre console. Work a plastic trim tool under the edge, usually starting at the rear, and lift gradually around the frame. Some cars use screws hidden under the gaiter or inside a storage tray, so if it does not move with light pressure, stop and look for a screw.

  3. Find out how the knob is fixed

    There are three common types. Screw-on knobs turn anticlockwise (they can be tight the first time). Push-fit knobs pull straight up with a firm, sharp pull, sometimes after a locking sleeve or collar is turned or released. On many Volkswagen group cars the gaiter is held to the knob by a metal clamp that is cut off and replaced with a small hose clip or cable tie.

  4. Separate the old gaiter

    Turn the gaiter inside out to see how it is held at the top (rubber ring, cable tie, clamp or elastic) and at the bottom (staples, glue, hooks or clips on the frame). Remove the old material carefully so you do not crack the plastic frame. Clean off loose glue.

  5. Fit the new gaiter to the frame

    Line up the seams and the front of the new gaiter with the frame. Fix it the same way as the original: hook it over the clips, staple it, or glue it with contact adhesive applied to both surfaces, working in small sections. Fold the edge under; there is no need to cut our gaiters.

  6. Fit the top and refit

    Fit the top of the gaiter to the knob or collar with the original ring, a new cable tie or clip. Refit the knob, then press the frame back into the console, checking that no clips or wires are trapped.

  7. Check every gear

    Move the lever through all gears (or P to D on an automatic) and operate the handbrake fully. The gaiter should fold neatly without pulling tight. Let adhesive cure as stated on the tin before heavy use.

Tips from our workshop

  • If you are not sure which version you have, e-mail us a photo of your original gaiter and frame and we will check it before making your new one.
  • Leather and Dinamica stretch a little in the first days; a light warm-up with a hairdryer helps the material settle around the frame.
  • Never force a frame that will not move: a hidden screw is cheaper than a broken console.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.