Land Rover Freelander 2 (2006-2014) Gear and Handbrake Gaiter Fitting Guide

The Freelander 2 gaiters wear quickly, especially the handbrake gaiter on the edge facing the driver. Both can be replaced at home with simple tools. The manual and automatic versions are slightly different at the knob, so check which you have before you start.

Time needed: 45-60 minutes

What you need

  • Plastic trim tools
  • Small flat-head screwdriver wrapped in tape
  • Contact adhesive for automotive upholstery
  • Clean cloth

Step by step

  1. Lift the trim around the lever

    The trim and gaiter are clipped into the console. Use a plastic trim tool or pull gently on the base of the gaiter to lift the trim. The small clips that hold the leather under the trim are fragile, so work slowly.

  2. Manual: remove the gear knob

    Push the gaiter down away from the knob. Underneath, the knob is held on the lever by plastic prongs. Grip the knob firmly and pull it straight up with a sharp pull; it needs more force than you might expect.

  3. Automatic: release the knob retainer

    On automatic cars a nylon retainer under the knob holds it in place. Owners report that turning the retainer a small amount (roughly from 12 o'clock to 2 o'clock) lets it drop down the lever, after which the knob comes off. Note the orientation of the retainer before you take it out.

  4. Handbrake gaiter

    The handbrake gaiter is clipped into its own trim. You do not normally need to remove the handbrake handle itself; lift the trim and work the gaiter off over the handle.

  5. Transfer the new gaiters

    Remove the old leather from the trim frames, keeping all clips and the frame intact. Line up the seams of the new gaiter, then fix it to the frame the same way as the original, using contact adhesive in small sections where it was glued.

  6. Refit and check

    Refit the knob or retainer, press the trims back into the console and check every gear position and full handbrake travel.

Tips from our workshop

  • Some of our Freelander 2 gaiters are supplied for fitting onto your original frame; the listing says when a frame is included.
  • If the opening at the top feels tight, warm the leather gently rather than cutting stitches.

Shop the parts for this car

General tips for any car: How to replace a gear gaiter and handbrake gaiter.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.