On the Discovery 1 and 2 the gear lever and the transfer box (hi-low) lever use the same fitting method, so once you have done one, the other is quick. The handbrake gaiter is fitted in a similar way.
Time needed: 30-45 minutes
Each gaiter sits on a square plastic base clipped into the console. Squeeze the sides of the base and pull it up; it should come free without tools.
Slide the gaiter up towards the knob and unscrew the knob anticlockwise, turning the gaiter with it so it does not twist.
Turn the old gaiter inside out. At the top you will find a rubber band holding it to the knob: remove it and keep it for the new gaiter. Release the old material from the square base.
Fit the new gaiter to the square base, lining up the corners and seams. Turn it inside out over the knob and refit the rubber band at the top.
Screw the knob back on while turning the gaiter with it, then press the base back into the console. Repeat for the second lever and the handbrake.
Select every gear, high and low range, and pull the handbrake fully on to check the gaiters move freely.
General tips for any car: How to replace a gear gaiter and handbrake gaiter.
Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.
Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.