Saab 9-5 (1997-2010) Gear and Handbrake Gaiter Fitting Guide

The Saab 9-5 handbrake gaiter is attached to the upper part of the centre console, so the console top has to come off. It is a longer job than on most cars but needs only basic tools. Take your time with the connectors and the plastic clips.

Time needed: 1-1.5 hours

What you need

  • Torx and Phillips screwdrivers
  • Small flat-head screwdriver wrapped in tape
  • Masking tape and a pen to label connectors

Step by step

  1. Gear lever gaiter

    On manual cars lift the gear lever gaiter up out of the console first. On automatics the trim rim around the selector is prised up instead.

  2. Remove the rear console and switches

    Lift the rear part of the console straight up and unplug the switches (heated seats, cigarette lighter and others, depending on the car). Label each connector before you unplug it.

  3. Lift the console top

    Undo the screws holding the upper part of the console (the workshop manual lists six). Release the clip that holds the handbrake gaiter to the console top and lift the top away.

  4. Remove the old handbrake gaiter

    The gaiter sits on a plastic sleeve on the handbrake lever. Pull the old gaiter forwards over the lever (it is usually destroyed in the process) and prise the sleeve off with a screwdriver.

  5. Fit the new gaiter

    Turn the new gaiter inside out over the sleeve, slide the sleeve onto the handbrake lever, then turn the gaiter the right way out and push the sleeve fully home.

  6. Refit the console

    Clip the gaiter to the console top, refit the console, screws and all connectors, making sure the gear lever gaiter and wires are not trapped.

Tips from our workshop

  • Photograph the connectors before you unplug them; the left and right seat heater plugs are easy to swap by mistake.
  • A manual gear gaiter can be fitted at the same time while the console is apart.

Shop the parts for this car

General tips for any car: How to replace a gear gaiter and handbrake gaiter.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.