A cracked or worn Amarok armrest is easy to refresh: the new cover is fitted onto your original armrest lid with contact adhesive. These photos are from our own fitting video.
Time needed: 1-2 hours (plus adhesive curing time)
Remove the armrest lid to work on it at a bench. Where it is held by a clip, open it gently with a small flat-head screwdriver; too much force can break the plastic clips.

Peel the original cover off the lid slowly so the plastic base is not damaged. Clean away loose residue from the old adhesive.

Before using any adhesive, place the new cover over the lid. Centre the seams and check that the material sits evenly, then start fixing it only once it is in the right position.

Apply contact adhesive to the underside of the lid and the matching areas of the cover, following the instructions on the adhesive. Work in stages, especially at the front edge and the sides, and keep adhesive off the visible side of the material.

After the waiting time given on the adhesive, stretch the material evenly and press it onto the lid. Smooth out wrinkles as you go round the edges, then fold and fix the edges underneath. Do not trim the material.

Let the adhesive cure fully, refit the lid and check that the armrest opens and closes properly.


Watch it on our YouTube channel: VW Amarok (2010-2020) Armrest Cover Fitting Guide video
General tips for any car: How to replace a gear gaiter and handbrake gaiter.
Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.
Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.