Mazda MX-5 (NA, NB and NC) Gear and Handbrake Gaiter Fitting Guide

The MX-5 leather gear gaiter sits on top of a separate rubber boot that keeps heat and noise out of the cabin. When you replace the leather gaiter, it is a good moment to check that the rubber boot underneath is not split.

Time needed: 45-90 minutes

What you need

  • Phillips screwdriver
  • Small flat-head screwdriver
  • Staple gun or contact adhesive for automotive upholstery

Step by step

  1. Unscrew the gear knob

    On the NA, NB and NC the knob simply unscrews anticlockwise. It can be tight the first time.

  2. Release the console

    The leather gaiter is held by the centre console. Remove the console screws (on the NA there are two on each side) and lift the front of the console to guide the old gaiter over the lever. Unplug any switches or window wiring before pulling the console further.

  3. Separate the old gaiter

    Take the old gaiter off its frame or holder. Check the rubber boot underneath and replace it if it is split.

  4. Fit the new gaiter

    Fix the new gaiter to the original frame the same way as the old one, with staples or contact adhesive, keeping the seams centred.

  5. Handbrake gaiter

    Fit the matching handbrake gaiter while the console is loose; it is much easier to align with the console off.

  6. Refit and check

    Refit the console and all connectors, screw the knob back on and check all gears and full handbrake travel.

Tips from our workshop

  • Watch our MX-5 NB set in 7 stitching colours on YouTube (link below).
  • Leather settles in a few days; if the gaiter looks tight at first, warm it gently.

Watch it on our YouTube channel: Mazda MX-5 (NA, NB and NC) Gear and Handbrake Gaiter Fitting Guide video

Shop the parts for this car

General tips for any car: How to replace a gear gaiter and handbrake gaiter.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.