Porsche 911 (997, 2004-2012) Manual Gear Gaiter Fitting Guide

On the 997 the gaiter, its base ring and the gear knob come off together. The new gaiter is fitted to the original ring and knob, so take care of the small clips and the locking sleeve.

Time needed: 1-2 hours (plus adhesive curing time)

What you need

  • Plastic trim removal tool
  • Phillips and flat-head screwdrivers
  • Contact adhesive for automotive upholstery
  • Masking tape

Step by step

  1. Release the gaiter ring

    Wedge a plastic trim tool under the base ring of the gaiter and lift it off its clips in the console. Lift it gradually to avoid breaking the clips.

  2. Remove the knob

    According to the Porsche procedure, the leather sleeve at the base of the knob is turned to unlock the knob, which then pulls up off the lever. When refitting, the knob is pushed fully on and the sleeve is turned anticlockwise about 90 degrees until it stops.

  3. Separate the old gaiter

    Remove the old gaiter from the base ring and the knob. Note how far the material wraps around the ring before you remove it.

  4. Fit the new gaiter

    Glue the new gaiter to the base ring with contact adhesive, wrapping the material around the bottom of the ring, and fit the top to the knob. Use masking tape to keep adhesive off the visible surface.

  5. Refit

    Slide the knob and gaiter over the lever until it seats, lock it and snap the ring back onto its clips. Check every gear including reverse.

Tips from our workshop

  • See the 997 listing for the materials and stitching colours available.
  • Allow the adhesive to cure overnight before driving hard.

Shop the parts for this car

General tips for any car: How to replace a gear gaiter and handbrake gaiter.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.