MG MGF and MG TF Gear and Handbrake Gaiter Fitting Guide

On the MGF and TF the handbrake gaiter is attached to a plastic moulding under the handbrake grip, and the gear gaiter sits in a plastic ring under the console. Both can be done at home with basic tools.

Time needed: 45-60 minutes (plus glue drying time if used)

What you need

  • Mole grips (wrap the jaws in cloth)
  • Large flat-head screwdriver
  • Stubby Phillips screwdriver
  • Staple gun or contact adhesive for automotive upholstery

Step by step

  1. Free the handbrake grip

    The original grip is often glued to the lever. Twist the grip with protected mole grips to break the seal.

  2. Release the front clip

    Put a flat-head screwdriver into the front end of the grip and push rearwards and upwards to release the front clip, then remove the grip and gaiter together.

  3. Transfer the handbrake gaiter

    Remove the staples from the plastic moulding to release the old gaiter. Staple or glue the new gaiter to the moulding; if you glue it, let it harden overnight.

  4. Gear gaiter

    Lift the console to reach the plastic ring under the gear gaiter. It is held by two screws at the front and two clips at the rear. Release them, push the old gaiter down through the console and fit the new one into the ring, with the front of the gaiter facing forwards.

  5. Refit and check

    Refit the ring and console, then refit the handbrake grip and gaiter. A little glue on the handbrake stalk stops the grip from turning.

Tips from our workshop

  • Refit the console with the gear gaiter in place first, then fit the handbrake gaiter.
  • Matching gear and handbrake gaiters in the same leather and stitching give the neatest result.

Shop the parts for this car

General tips for any car: How to replace a gear gaiter and handbrake gaiter.

Not sure which version you need? E-mail a photo of your original part to info@tuning-shop.co.uk or call 01209 822344 and we will check it for you.

Vehicle names are used only to describe compatibility. Fitting is at your own risk; if in doubt, ask a qualified trimmer or mechanic.